Filter
Top Products
1
2
3
4
5
6
7
8
9
10
11
12
5-9
4
After selecting the paper type corresponding to the
type of the paper that has been set, press the SET
key.
- When selecting OHP film, the hole punch mode and the
staple mode cannot be used.
If you select the paper type not corresponding to the type of
the paper that has been set, it may cause a problem such as
a paper jam, significant image deterioration, etc.
Select other copy modes as required.
5
Press the START key.
3
If the paper other than standard type has been set,
press the PROGRAM key to enter the program
menu, and press BYPASS FEED key.
- If the standard size paper has been set, you do not have to
perform steps 3 to 4.
2
Place the original(s). Page 2-9
- If you press the MEDIA TYPE key on the right menu, which
is displayed when placing paper on the bypass guide, the
menu of step 4 is also displayed.