Filter
Top Products
Part V Composer
108
QQTG0692
Composer
Recording procedure
1.
In the START RECORDING area on the dis-
play, select the rhythm part you want to record
first.
BAS: BASS
AC1–5: ACCOMP 1–5
DR1, 2: DRUMS 1, 2
• The metronome sound starts and the display
looks similar to the following.
2.
Adjust the tempo.
• The tempo is shown on the display as
q
=.
• The tempo can be freely adjusted when you
play back the rhythm pattern, so record at the
tempo which is easiest for you to play.
3.
Select the sound.
• For the DRUMS part, only sounds from the
DRUM KITS sound group can be selected.
•For the ACCOMP and BASS parts, select
sounds from groups other than the DIGITAL
DRAWBAR sound groups.
• The sounds marked with # represent special
guitar performances and changing them to
other sounds may result in an unnatural, awk-
ward sound expression.
4.
Record the part.
• The specified number of measures are repeat-
edly played back, during which time any newly
played notes are added to those already
recorded. The current measure number is
shown on the display as “MEASURE=”.
• Record the performance in C major for correct
chord progressions during playback. Follow
the KEY SETTING procedure if you wish to
record the performance in a different scale.
• PITCH BEND, MODULATION (KN2600)
(except for the DRUMS part) effects are also
recorded.
• The SUSTAIN ON/OFF is also stored (except
for the DRUMS part).
Ⅲ
ⅢⅢ
Ⅲ
Button functions
PART BALANCE:
Adjust the volume of each part on the PART
BALANCE display. (These settings are not
recorded.)
PART SETTING:
You can make detailed settings for each part.
(Refer to page 110.)
STEP RECORD:
Change to the STEP RECORD mode. (Refer
to page 111.)
SOLO:
Mute all parts except the part which is cur-
rently being recorded.
• A MUTE mark is shown for the other parts on
the display.
• To turn off the SOLO function, press this but-
ton again.
PART CLR:
Erase all recorded contents of the currently
selected part.
NOTE CLR:
Data is erased one note or one percussion
instrument (DRUMS part) sound at a time.
• Hold and press this button, and press the key-
board key that corresponds to the note or per-
cussion instrument (DRUMS part) sound you
wish to erase.
ALL ERAS:
The performance recorded in the selected part
is erased for as long as this button is pressed.
QUANTIZE:
Smooth out any unevenness in the timing of
your performance.
• Before recording, select the note value for the
desired quantize level. (The quantize level is
shown on the display as QUANTIZE=.)
10_Part V.fm 108 ページ ２００３年１月２７日 月曜日 午後１時４５分