Filter
Top Products
Part X Sound Edit
166
QQTG0692
Sound Edit
ENVELOPE
Specify how the volume changes over time, from
the time the key is played to the time the sound
dies out.
1.
Use the PAGE buttons to view the 2/3 display.
• The display looks similar to the following.
2.
Use the buttons to the left of the display to
select a tone.
• Use the ▲ and ▼ buttons to select a setting
item and then the
∧
and
∨
buttons to specify a
selection.
3.
Adjust the settings for the volume envelope.
• Use the buttons below the display to set the
corresponding values. The envelope is cre-
ated on the display as you input the settings.
• Use the SUSTAIN PEDAL
∧
and
∨
buttons to
select the type of sustain.
LONG:
Extend the release time of the sound.
HOLD:
Maintain the key-pressed condition.
4.
Repeat steps 2 and 3 for the other tones, as
desired.
ENVELOPE TOUCH & KEY FOLLOW
Specify how the volume changes relative to
touch or note pitch over time.
1.
Use the PAGE buttons to view the 3/3 display.
2.
Use the buttons to the left of the display to
select a tone.
• Use the ▲ and ▼ buttons to select a setting
item and then the
∧
and
∨
buttons to specify a
selection.
3.
Change the touch settings.
• Use the TOUCH ATTACK
∧
and
∨
buttons to
specify the ATTACK time change depending
on touch. Use the TOUCH DECAY
∧
and
∨
buttons to specify the DECAY time change
depending on touch.
• At a − setting, the softer the keys are pressed,
the greater the change. At a + setting, the
harder the keys are pressed, the greater the
change.
4.
Change the key follow settings for the
ATTACK, DECAY and RELEASE.
• Use the RANGE buttons to specify the key-
board range.
15_Part X.fm 166 ページ ２００３年２月５日 水曜日 午後１時５５分