Filter
Top Products
Part II Playing the rhythm
65
QQTG0692
Playing the rhythm
Assign a name to the bank/memory
You can assign names to the banks and memo-
ries.
1.
Select a bank or memory.
2.
Use the PAGE buttons to go to the PAGE 2/2
page on the display.
3.
Press the BANK NAMING button to assign a
name to the bank, or the MEMORY NAMING
button for the memory.
• The display looks similar to the following.
4.
Use the buttons below the display to assign a
name.
• Set the character input position with the POSI-
TION buttons, select the characters with the
alphanumeric buttons and repeat name
assignment.
• Switch from upper to lower case letters with
the ABC, abc button.
• Press the INS button to enter a space at the
cursor position.
• Press the DEL button to erase the character at
the cursor position.
• Press the CLR button to erase the entire
name.
• Press the →← button to center the name.
5.
When you have finished assigning the name,
press the OK button.
Recall the panel setup
1.
Press the BANK VIEW button to turn it on.
Select a bank.
2.
Press the desired PANEL MEMORY number
button (1 to 8).
• The panel setup changes to the one stored in
the specified memory.
• You can then change the sound settings, etc.
manually; however, the contents of the mem-
ory remain unchanged until you store them
again.
• The “Control Preset” bank of the PERFORM-
ANCE PADS or the Foot Switch (sold sepa-
rately) can also be used to change from one
PANEL MEMORY setup to another. (Refer to
pages 64, 172.)
• The currently selected bank, memory number
and memory name are shown in the top line
on the normal display.
Ⅲ
ⅢⅢ
Ⅲ
NEXT BANK
You can press the NEXT BANK button to switch
to the next bank. This allows you to change
banks without exiting the normal display.
• Each time the NEXT BANK button is pressed,
the bank indication changes in order (A ➝ B
➝ C ➝ A ➝ B ...).
• The panel settings change when a PANEL
MEMORY number button (1 to 8) is pressed.
NEXT BANK
07_Part II.fm 65 ページ ２００３年２月５日 水曜日 午後２時４０分