Filter
Top Products
Part VI Disk Drive (KN2400)
120
QQTG0692
Disk Drive (KN2400)
Loading data
Recall (load) the data from the disk to this instrument’s memories.
• Note that the load procedure causes any data which is currently stored in the relevant memories to be
erased.
LOAD
Load data that saved to a disk into this instru-
ment’s memory.
1.
Insert the disk with the stored data into the
Disk Drive. Push it all the way in until you hear
a click.
2.
On the DISK MENU display, select LOAD.
• The display looks similar to the following.
• If there are only SMF files on the disk, the dis-
play automatically changes to the SMF LOAD
display.
3.
Use the buttons below the display to select the
song (Technics file) you wish to load.
• If there are SMF files on the disk and you wish
to load an SMF file, press the SMF button.
(Refer to next page.)
4.
Press the LOAD button.
• The LOAD operation begins.
• When the operation has been successfully
completed, “COMPLETED!” is shown on the
display.
• If song data was loaded, you can press the
START/STOP button to begin playback when
the SEQUENCER PLAY display is active.
• You can load the type of data for which only
one song can be recorded in the
SEQUENCER. (This type is available for disks
used with older Technics models.) Note, how-
ever, that in this case, the song is loaded into
SONG 1, but the data in SONG memories 2 to
10 are erased.
• You can also access the LOAD display by
pressing the DISK button for a few seconds.
Ⅲ
ⅢⅢ
Ⅲ
LOAD OPTION
Specify the kind of data you wish to load from the
disk to your instrument.
1.
Use the PAGE buttons to access the PAGE
2/3 LOAD OPTION display.
• The display looks similar to the following.
2.
Use the buttons below the display to specify
the types of data you wish to load (YES/NO).
• - - - - - indicates that this type of data has not
been saved.
• This setting is canceled when you quit the
LOAD display or when another file is selected.
3.
Press the LOAD button.
• The LOAD operation begins.
11_Part VI.fm 120 ページ ２００３年２月５日 水曜日 午後２時４３分