Filter
Top Products
Part IV Sequencer
90
QQTG0692
Sequencer
Store a rhythm progression
Changes in the rhythm selection and tempo, as well as the intro, fill-ins and the ending, can be stored by
measures with the step recording method.
1.
On the SEQ MENU display, use the SONG
∧
and
∨
buttons to select the song number.
Then select RECORD & EDIT.
2.
On the RECORD & EDIT display, select STEP
RECORD.
• The display changes to the PART SELECT
display.
3.
Using the balance buttons below the display,
select the track to which the RHYTHM (RHY)
part has been assigned.
• The display changes to the STEP RECORD:
RHYTHM input display similar to the following.
4.
Use the MEAS ▲ and ▼ buttons to go to the
measure you wish to record.
5.
Store the rhythm data.
• Data which can be stored:
START/STOP
Changes in the rhythm selection
RHYTHM VARIATION 1–4,
COUNT INTRO, INTRO, FILL IN,
ENDING
Tempo changes
• Be sure to store the START/STOP data in the
measure in which the rhythm starts or stops.
• If you are storing a COUNT INTRO or INTRO,
store this data before the START/STOP data.
• If the tempo is changed, the display changes
to the confirmation display. After specifying
the desired tempo, Press the YES button to
store the specified tempo, or press the NO
button to cancel the new tempo value.
6.
Repeat steps 4 and 5 to continue storing the
rhythm progression.
7.
At the end of the rhythm progression, press
the END button.
• If the REP button is pressed instead of the
END button, during playback the recorded
rhythm progression is repeated.
• The Keyboard exits the recording mode.
Ⅲ
ⅢⅢ
Ⅲ
Correct the recorded rhythm progression
1.
Follow the procedure to select the STEP
RECORD: RHYTHM display.
2.
Use the MEAS buttons to go to the measure
you wish to modify. (The
∗
is highlighted.)
3.
Correct the rhythm data.
• Press the ERS button to erase data at the cur-
sor position.
• If you wish to cancel the REPEAT, enter an
END command.
• If you select a rhythm with a different time sig-
nature, the time signature of all subsequent
measures will also change.
• If data has already been recorded in other
tracks, you cannot select a rhythm with a dif-
ferent time signature.
Ⅲ
ⅢⅢ
Ⅲ
TRACK CLEAR
To erase all data from the current track, press
the CLR button, and then press the YES button
on the confirmation display.
• If you wish to cancel the clear procedure,
press the NO button.
09_Part IV.fm 90 ページ ２００３年２月５日 水曜日 午後１時３４分