Filter
Top Products
22 C2928M-A (4/07)
6. Press ENTER on the remote. A checkmark appears next to the selection and the picture and menus are inverted. The left-right of the optical
engine alignment motors are also reversed to make the left-right orientation correct for viewing.
Figure 13. Inverted Installation
ADJUSTING ANALOG 1 AND ANALOG 2 INPUT
Displays differ from one another because of very small differences in the color of the light produced by the lamp and by differences in the dyes
used to make the color in a DLP optical engine. Adjusting all the displays in a wall ensures that the image produced will be uniform in
appearance.
INPUT LEVEL ADJUSTMENT, AUTOMATIC
NOTE: For superior results, semiautomatic adjustment of the black and white levels is recommended. Refer to the Input level Adjustment,
Semiautomatic section.
To set the Auto Setup functions, refer to Figure 14 and do the following:
1. Press MENU on the remote.
2. Scroll down to Advanced Options, and then press +.
3. Scroll down to Auto Setup Options, and then press +.
4. Scroll down to Do Black/White Levels, and then press ENTER to select it.
The following functions have been preselected:
Retry on lost signal: If video is lost on the current input, the display will search for and display video from another input.
Do Frequency: This feature automatically adjusts the frequency of the electronics module to match the frequency of the video signal.
Do Phase: This feature automatically adjusts the phase of the electronics module to match the phase of the video signal.
Do Position: This feature puts the upper left pixel of the picture in the upper left corner of the screen.
Main Menu
Picture
Size & Position
Advanced Options
Program Information
Aspect Ratio & Wall
Memory
Diagnostics
Advanced Options
Color Balance
Miscellaneous Options
Engine Alignment
Menu Options
Lamp Settings
Serial Port Settings
Auto Setup Options
Miscellaneous
Beeper
Curtain Pattern
Preferred Source Detection 16 x 9
HD Interlaced Content
White
Normal
Auto Codes
Plug and Play (EDID Enable)
Inverted Installation