Filter
Top Products
C2928M-A (4/07) 53
REMOVING THE LAMP FROM THE REAR
1. To change the lamp from the rear, refer to Figure 40 and Figure 41 and do the following:
2. Turn off the AC power switch, and then remove the cord. Refer to the Shut-Down Sequence section.
3. Remove the six 1/4-turn screws located on the rear panel.
4. Loosen the lamp screw on the right rear of the lamp.
5. Move the lamp to the rear about 3/8 of an inch (1 cm) and then right.
6. Lift the lamp out, still connected to the electronics module.
7. Disconnect the lamp cable.
Figure 41. Rear Panel Screws
DANGER: Turn off and disconnect power from the unit before replacing the lamp. Voltage present at the lamp can cause serious injury or
death.
REAR PANEL SCREWS