Filter
Top Products
C2928M-A (4/07) 45
TERMINATION
In some cases, it may be necessary to terminate the last display in a series. In most instances, this is not necessary. Terminating the loop
unnecessarily can cause communication problems. If communication of commands appears to be working properly with all displays in the wall,
do not terminate the series.
To terminate the last display in a serial loop, refer to Figure32 and do the following:
1. Press MENU on the remote.
2. Scroll down to Advanced Options, and then press +.
3. Scroll down to Serial Port Settings, and then press +.
4. Scroll down to Terminate RS-485.
5. Press ENTER on the remote to select the check box to activate termination.
6. Press MENU to close the menu.
Figure 32. RS-485 Termination
Main Menu
Picture
Size & Position
Advanced Options
Program Information
Aspect Ratio & Wall
Memory
Diagnostics
Advanced Options
Color Balance
Miscellaneous Options
Engine Alignment
Menu Options
Lamp Settings
Serial Port Settings
Auto Setup Options
Serial Port Settings
Group ID
Unit ID
ASCII Response Type
ASCII Response Terminator
Baud Rate
2
6
Symbolic
CR
2400
Terminate RS-485