Filter
Top Products
C2928M-A (4/07) 39
4. Scroll down to Auto Lamp On.
5. Press ENTER on the remote to select (check mark) or deselect (no check mark) the check box.
6. Scroll down to Lamp Saver.
7. Press ENTER on the remote to select (check mark) or deselect (no check mark) the check box.
8. If Lamp Saver is selected, do the following:
NOTE: The Lamp Saver Timeout value cannot be set lower than 5 minutes.
a. Scroll down to Lamp Saver Timeout (hr).
b. Press the + button on the remote to increase the value.
c. Press the – button to decrease the value.
9. Press the MENU button on the remote to close menu.
SHUT-DOWN SEQUENCE
The lamp fan runs continuously while the lamp is on. When the lamp is turned off, the intake fan shuts off 15 seconds later, while the lamp fan
continues to run for an additional 5 minutes to cool the lamp. If the display must be disconnected from power, do the following:
1. Press OFF on the remote control.
2. Wait for the lamp fan to stop running.
3. Press the AC power switch on the rear of the display to turn off the power.
4. Remove the power cord from the AC in receptacle.
WARNING: Turning off the PMCD750 display by turning off the power switch does not allow the lamp to cool down properly. Turning the
display off by this method may significantly shorten the service life of the lamp.