Filter
Top Products
C2928M-A (4/07) 23
Figure 14. Auto Setup
5. Press MENU to close the menu.
6. Press SETUP on the remote control. The display will now perform an automatic adjustment of the black and white levels, as well as all of
the other functions selected in the Auto Setup Options menu.
INPUT LEVEL ADJUSTMENT, SEMIAUTOMATIC
NOTE: When the source image controller used for adjustments is changed, the associated input will require readjustment to the new source.
To adjust each PMCD750 input level, refer to Figure 15 and do the following:
1. Display a black image. A black screen image can be created in many graphics software. The source used for these adjustments must be the
same source that is going to be used regularly to display images.
2. Press the MENU button on the remote control.
3. Scroll down to Picture and then press +.
4. Scroll to Source and then press +.
5. Scroll to either Analog 1 or Analog 2, relative to the input being used, and then press ENTER. This will display the input source on the
screen and all adjustments made will affect this input.
6. Scroll down to Input Levels, and then press +.
7. Scroll to Auto Black Level, and then press ENTER.
8. Display a white image from the controller.
9. Scroll to Auto White Level, and then press ENTER.
10. Press MENU to close the menu.
Main Menu
Picture
Size & Position
Advanced Options
Program Information
Aspect Ratio & Wall
Memory
Diagnostics
Advanced Options
Color Balance
Miscellaneous Options
Engine Alignment
Menu Options
Lamp Settings
Serial Port Settings
Auto Setup Options
Auto Setup Options
Retry on lost signal
Do Black/White Levels
Do Frequency
Do Phase
Do Position