Filter
Top Products
46 C2928M-A (4/07)
ASSET TAG AND UNIT STATUS
The Asset Tag feature displays specific information relative to serial number and current status of the PMCD750 display.
To display the asset tag information, refer to Figure 33 and do the following:
1. Press MENU on the remote.
2. Scroll down to Diagnostics.
3. Press + on the remote.
4. Scroll to Unit Status.
5. Press +. The following information is displayed:
1280 x 720
The resoulution of the display.
Rev X.X
The revision number of the firmware currently operating in this unit.
Optical Engine SN
The serial number read from the optical engine in this unit.
Asset Tag
An editable text line. A short message can be inserted here using RS-232 commands. It is recommended to enter the serial number of this
display here, unless your facility has a special method of identifying property. Refer to the Connecting RS-232 and RS-485 Control section
and the manual for the external controller used for more information.
PS Fan and Eng Fans
If these fans are not on, the lamp will not be on, and the menu would not be visible.
Lamp
If the lamp is off, the menu would not be visible.
Interlock
If the interlock is Open, the lamp will not light (unless the interlocks have been bypassed to service the display).
Mode ID
The number of the mode (type of signal) currently set.
HPer
The horizontal period in nanoseconds (ns) of this signal (picture).
VLines
The number of vertical lines in the picture. This number will be larger than the vertical resolution, because it includes vertical blanking lines
that are not visible.
Last Fault
The last event that forced the lamp off, followed by the number of hours and minutes elapsed since the fault occurred, measured in system
hours, not clock time.