Filter
Top Products
MGC+ Hardware and Installation Manual
2-9
1. Check that all the parts are in the kit.
The kit should contain the following items:
2. Make sure that the MCU power is turned OFF and it is disconnected
from the AC power.
Remove the side covers as described on page 2-4.
3. If the MCU is a standalone unit, you must first remove the side covers,
and add the mounting brackets to a 23” rack (see pages 2-4 to 2-6).
4. Attach the two mounting bars to the MCU as follows:
a. Fit the spring washer (Item #3) onto the screw (#2).
Because of heat considerations, the MCU must be installed with the Control Unit
Module placed on the left bottom.
Table 2-1: 19” Rack Mounting Kit
Item # Polycom P/N Description Quantity
1 MEC2063A 23" TO 19" Mounting Bar
MGC+100 at 90 Degrees
2
2 SCR2005A Screw 10-32 x 1/2” Allen S/H
ST/ST
8
3 WAS2003A Washer M5 Spring Latch Loc.
ST\ST
8
4 WAS2004A Washer M5 Flat ST/ST 8
Item #3