Polycom DOC2238A Network Router User Manual


 
Chapter 2 - Hardware Installation
2-40
Compact Flash Memory Use on the MGC+
The Main Control Unit’s Compact Flash port is used to perform the following
tasks:
pSOS Rescue Disk
Contact you next level of support
Swapping the Operating System (OS)
Contact your next level of support
First Entry MGC+ Control Unit (CU) IP Configuration using:
pSOS OS
XPEK OS
The Compact Flash slot is located on the Main Control Module, below the
Flash Memory LED. When the Flash Memory is active, the LED
flashes.
Power
Out
In
Power
Out
In
Power
Out
In
P
O
L
Y
C
O
M
R
MGC+
Line 1
Line 1
Line 2
Line 2
Line 3
Line 3
Line 4
Line 4
Line 5
Line 6
Line 7
Line 8
Flash Memory Card
Eject Button
Do not press the Reset button or turn the system OFF while the Flash Memory
LED is flashing.