Chapter 2 - Hardware Installation
2-32
Connecting and Setting Up the MGC+50
Use the MGC+50 rear panel diagram below for reference.
Figure 2-14: MGC+50 Rear Panel with External Connectors
To connect the MGC+50 to the network and power source and set up the
system the following procedures are performed:
• Connecting the MGC+ unit to the power source (AC inlet)
• Connecting the MGC+ unit to the LAN Network (C.B., I/O)
• Connecting the MGC+ unit to the Operator Workstation (PC) directly via
COM2 (optional)
• Connecting the MGC+ unit to the network(s)
MGC+50 Dongle
MGC+50 is shipped with a serial dongle and is installed on COM1 of the
Control unit’s rear I/O panel. A special bracket ensures that the dongle
remains in its fixed position. The dongle is required for normal operation of
the MCU. If the dongle is missing, please contact support.
DEBUG
LINE IN
COM2
COM1
KEYBOARD
MOUSE
VGA
LAN
COM2
COM1
KEYBOARD
MOUSE
VGA
LAN
ALARMS