Filter
Top Products
MGC+ Hardware and Installation Manual
2-15
Installing the I/O Card for the ReadiManager IAM
To install the I/O card for the ReadiManager IAM:
1. Remove the right rear I/O cover by loosening the four screws as shown
in the following illustration.
Figure 2-5: MGC+ 50/100 rear panel detachment
2. Remove the I/O card for the ReadiManager IAM from its package and
insert it in its slot as shown in the following illustration.
Figure 2-6: MGC+ ReadiConvene IAM rear I/O Insertion
3. Push the I/O card firmly into the MGC+ backplane. Make sure its is
properly seated in its slot.
4. Tighten the four screws that secure the I/O card to the MGC+ chassis.
5. Attach the required cables or connections to the I/O card for the
ReadiManager IAM.