Filter
Top Products
Chapter 1-
1-2
RSS 2000 Installation and Preliminary Configuration
Unpacking and Installing the RSS 2000
1 Place the RSS 2000 unit on a stable flat surface in the selected location.
2 To connect to the power source, insert the power cable into the Power
connector on the rear panel of the RSS 2000 unit and insert the Power
cable into the power source socket.
3 Connect the LAN cable to LAN 1 port on the rear panel of the RSS 2000
unit.
4 Turn on power switch.
Figure 1-2 Cables Connection
Initial RSS 2000 IP Configuration
The system is shipped with a default IP address:
IP Address: 192.168.1.254
Subnet Mask: 255.255.255.0
Gateway: 192.168.1.1
There are two ways to change the initial IP address of the system:
• Via a cross over LAN cable
• Via a RS232 or Telnet Console.
Changing the initial IP address via a cross over LAN cable
1 Connect a cross over LAN cable to LAN 1 port on the rear panel of the
RSS 2000 unit..
2 Configure your PC to the same segment of the RSS 2000. For example,
set the IP address as that shown below: