Filter
Top Products
Polycom RSS 2000 User Guide
2-31
Click on “Recording Settings” in the navigation bar on the left side of the
page, and make settings on these pages for the RSS 2000’s single point
recording properties, point-to-point recording properties, web dial-out
recording, and multicast videos.
Single Point Recording Settings
Click on “Recording Setting -> Single Point Settings” to enter the Single Point
Settings page. Here the administrator can configure the settings for the
single point recording parameters. When an endpoint dials the RSS 2000 to
start single point recording, that session will function according to these
parameters. In the single point recording settings the administrator can
separately set whether or not to record H.239 dual video, request I-frames at
specified intervals during recording, whether or not to allow live streaming
of the video during recording, and recording rights and viewing rights.
Figure 2-36 Recording Settings Page
Recording H.239 Dual Video
Check the Record my PC content if H.239 is supported by the endpoints box
and then when doing single point recording, the user will send H.239 dual
video PC screen to the endpoints. The recording rate of the H.239 content is 1
frame/second. When playing back recorded videos in Windows Media
Player or RealPlayer, it will open two video windows showing the video
image and the PC screen, as shown below. The recorded dual video PC
screen can support XGA resolution.