Filter
Top Products
Rev.2.00 Nov 28, 2005 page 186 of 378
REJ09B0124-0200
M16C/6N Group (M16C/6NK, M16C/6NM) 15. Serial Interface
Under development
This document is under development and its contents are subject to change.
Table 15.15 Registers to Be Used and Settings in Special Mode 2
Register Bit Function
UiTB
(1)
0 to 7 Set transmission data
UiRB
(1)
0 to 7 Reception data can be read
OER Overrun error flag
UiBRG 0 to 7 Set a transfer rate
UiMR
(1)
SMD2 to SMD0 Set to “001b”
CKDIR Set this bit to “0” for master mode or “1” for slave mode
IOPOL Set to “0”
UiC0 CLK1, CLK0 Select the count source for the UiBRG register
CRS Invalid because the CRD bit = 1
TXEPT Transmit register empty flag
CRD Set to “1”
NCH Select TXDi pin output format
CKPOL Clock phases can be set in combination with the CKPH bit in the UiSMR3 register
UFORM Set to “0”
UiC1 TE Set this bit to “1” to enable transmission
TI Transmit buffer empty flag
RE Set this bit to “1” to enable reception
RI Reception complete flag
U2IRS
(2)
Select UART2 transmit interrupt cause
U2RRM
(2)
, Set to “0”
UiLCH, UiERE
UiSMR 0 to 7 Set to “0”
UiSMR2 0 to 7 Set to “0”
UiSMR3 CKPH Clock phases can be set in combination with the CKPOL bit in the UiC0 register
NODC Set to “0”
0, 2, 4 to 7 Set to “0”
UiSMR4 0 to 7 Set to “0”
UCON U0IRS, U1IRS Select UART0 and UART1 transmit interrupt cause
U0RRM, U1RRM Set to “0”
CLKMD0 Invalid because the CLKMD1 bit = 0
CLKMD1, RCSP, 7 Set to “0”
i = 0 to 2
NOTES:
1. Not all register bits are described above. Set those bits to “0” when writing to the registers in Special
Mode 2.
2. Set the bit 4 and bit 5 in the U0C1 and U1C1 registers to “0”. The U0IRS, U1IRS, U0RRM and U1RRM
bits are in the UCON register.