Filter
Top Products
Rev.2.00 Nov 28, 2005 page 200 of 378
REJ09B0124-0200
M16C/6N Group (M16C/6NK, M16C/6NM) 15. Serial Interface
Under development
This document is under development and its contents are subject to change.
15.2.1 SI/Oi Operation Timing
Figure 15.39 shows the SI/Oi operation timing.
Figure 15.39 SI/Oi Operation Timing
15.2.2 CLK Polarity Selection
The SMi4 bit in the SiC register allows selection of the polarity of the transfer clock.
Figure 15.40 shows the polarity of the transfer clock.
Figure 15.40 Polarity of Transfer Clock
D7D0 D1 D2 D3 D4 D5 D6
(NOTE 2)
SI/Oi internal clock
CLKi output
Signal written to the
SiTRR register
SOUTi output
SINi input
IR bit in SiIC register
"H"
"L"
"H"
"L"
"H"
"L"
"H"
"L"
"H"
"L"
"1"
"0"
SiTRF bit in
S3456TRR register
"1"
"0"
i = 3 to 6 (5 and 6 are only in the 128-pin version.)
* This diagram applies to the case where the bits in the SiC register are set as follows:
SMi2 = 0 (SOUTi output)
SMi3 = 1 (SOUTi output, CLKi function)
SMi4 = 0 (transmit data output at the falling edge and receive data input at the rising edge of the transfer clock)
SMi5 = 0 (LSB first)
SMi6 = 1 (internal clock)
NOTES:
1.If the SMi6 bit = 1 (internal clock), the serial I/O starts sending or receiving data a maximum of 1.5 transfer clock cycles after writing to the
SiTRR register.
2.When the SMi6 bit = 1 (internal clock), the SOUTi pin is placed in the high-impedance state after the transfer finishes.
1.5 cycle (max.)
(1)
D1 D2 D3 D4 D5 D6 D7
D1 D2 D3 D4 D5 D6 D7
D0
D0
SOUTi
SINi
CLKi
D1 D2 D3 D4 D5 D6 D7D0
D1 D2 D3 D4 D5 D6 D7D0
SOUTi
SINi
CLKi
(2) When SMi4 bit in SiC register = 1
(1) When SMi4 bit in SiC register = 0
i = 3 to 6 (5 and 6 are only in the 128-pin version.)
*This diagram applies to the case where the bits in the SiC register are set as follows:
SMi5 = 0 (LSB first)
SMi6 = 1 (internal clock)
NOTES:
1.When the SMi6 bit = 1 (internal clock), a high level is output from the CLKi pin if not
transferring data.
2.When the SMi6 bit = 1 (internal clock), a low level is output from the CLKi pin if not
transferring data.
(NOTE 2)
(NOTE 1)