Filter
Top Products
Appendix
150
8
IEEE 802.11b (Wireless LAN)
has a problem.
IEEE 802.11b interface unit
was not inserted when the ma-
chine was turned on, or it was
pulled out after the machine
turned on.
The settings are not updated
although the unit is detected,
or errors are found while ac-
cessing the unit.
Turn off the machine and
check the IEEE 802.11b inter-
face unit is inserted correctly.
Then, turn the machine on
again. If the message appears
again, call your service center.
Paper in staple tray. Open
Finisher Cover and remove
paper.
There is paper remaining in-
side the finisher.
Open the cover of the finisher,
and remove the paper.
Parallel I/F board has a prob-
lem.
An error has occurred in the
parallel interface board.
Contact your sales or service
representative.
Printer font error. An error has occurred in the
font settings.
Check the font settings.
Memory Overflow Maximum capacity of PCL or
PostScript 3 list display has
been exceeded.
Reduce the value of [Resolu-
tion:] in the printer driver. Al-
ternatively, select [Frame
Priority] from [Memory Usage] in
[System] (see p.128 “System”).
If this message continues to
appear after taking these
steps, decrease the number of
files sent to the machine.
DToner is almost empty. The toner has almost run out. Replace the toner cartridge
with a new one.
USB has a problem. An error has occurred in the
USB interface.
Turn off the main power
switch, and back on again. If
the message appears again,
contact your sales or service
representative.
Messages/Second messages Causes Solutions