Ricoh 3030 All in One Printer User Manual


 
Installing the Printer Driver Using IEEE 1394 (SCSI print)
51
2
E Specify the location where the source files of the printer driver is stored,
and then click [Next >].
If the CD-ROM drive is D, the source files of the printer driver are stored in
the following location:
•RPCS
D:\DRIVERS\RPCS\WIN2K_XP\(Language)\DISK1
•PCL 5e
D:\DRIVERS\PCL5E\WIN2K_XP\(Language)\DISK1
•PCL 6
D:\DRIVERS\PCL6\WIN2K_XP\(Language)\DISK1
•PostScript 3
D:\DRIVERS\PS3\WIN2K_XP\(Language)\DISK1
When installation is complete, the printer connected to “1394_00n” appears in
the [Printers and Faxes] window. (“n” shows the number of printers connected.)
F Follow the on-screen instructions.
Note
If the printer driver has already been installed, the printer icon is added to
the [Printers and Faxes] window. In this case, printer driver installation is
not necessary.
Even if the printer driver is already installed, the message “Found New
Hardware Wizard” may appear when the machine is connected to the
computer using the IEEE 1394 interface cable for the first time. In that case,
install the printer driver.
If printing does not work properly after the installation, delete the port and
reinstall the printer driver. For details, see p.151 “The Machine Does Not
Print”.
If you do not want to install the printer when Found New Hardware Wiz-
ard starts under an operating system that supports SCSI print, disable the
device by following the procedure below:
A When the [Found New Hardware Wizard] dialog box appears, check that
[This wizard helps you install software for: Unknown] is displayed, select the
[Install from a list on specific location (Advanced)] check box, and then click
[Next >].
B When the message “Please choose your search and installation option.”
appears, clear all check boxes from [Search for the best driver in these loca-
tions.], and then click [Next >].
C When the message “The wizard could not find the software on your
computer for..” appears, click [OK].
D When the message “Cannot Install this Hardware” appears, select the
[Don't prompt again to install the software] check box, and then click [Finish].