Filter
Top Products
Settings
105
9
Settings
Scan Settings
This section explains how to set the
defaults for scan settings.
The scan settings consist of the fol-
lowing. For the table about settings
and defaults, see p.101 “Scanner Fea-
tures”.
❖ Default Scan Settings
Various basic settings (scan type,
resolution, image density, and
scan size) can be set. You can regis-
ter the scan settings in the same
way as specifying them. For de-
tails, see p.77 “Specifying Scan Set-
tings”.
•Scan Type
•Resolution
•Image Density
•Scan Size
❖ Wait Time for Next Orig.: Exposure
Glass
When dividing originals and scan-
ning them individually with the
exposure glass to form a single file,
select [Off], [Set Wait Time], or [Con-
tinuous Wait] for the waiting status.
Note
❒ If you select [SADF] in [Original
Feed Type] on the Scan to Folder
screen, the [Wait Time for Next
Orig.: Exposure Glass] setting be-
comes invalid.
❒ If you select [Batch] in [Original
Feed Type] on the Scan to Folder
screen, the [Wait Time for Next
Orig.: Exposure Glass] setting be-
comes invalid, and the machine
waits for an additional original
to be put in place.See p.80
“Batch/SADF selection”.
❒ If [Set Wait Time] is selected, en-
ter the wait time in seconds (3-
999) for placing additional orig-
inals with the number keys.
Scanning will start if additional
originals are placed and the
{Start} key is pressed within
this time. You can end scanning
and begin transmission by
pressing the {#} key within this
time. Once the specified time
has elapsed, transmission starts
automatically.
❒ If [Continuous Wait] is selected,
the machine will wait for addi-
tional originals until the {#} key
is pressed. Scanning will start
when additional originals are
placed and the {Start} key is
pressed. You can end scanning
and begin sending by pressing
the {#} key.
❒ If originals are placed in the au-
tomatic document feeder
(ADF), transmission will start
without waiting for additional
originals after all originals in
the ADF have been scanned, re-
gardless of the specified set-
tings.
❒ If a paper misfeed occurs or any
of the following operations is
performed while the machine is
waiting for additional originals,
the countdown stops and does
not start again until the {#} key
is pressed.
•Changing the settings such
as the scan settings
• Opening the upper cover of
the ADF
• Pressing the {Interrupt} key to
activate the copy mode