Filter
Top Products
UX1300U-TSDM
DD
<P=001>
MESSAGES AND SIGNALS
Display messages
CHECK PAPER SIZE
The paper size setting is incorrect. Change the
paper size setting as described in "Loading the
Paper" in Chapter 1.
COVER OPEN The printing compartment cover is open. Close it.
DOCUMENT JAM
The original document is jammed. See the
following section, "Clearing Paper Jams".
FAX RX IN MEMORY
A fax has been received in memory because the
imaging film needs replacement, you have run
out of printing paper, or the paper is jammed.
The fax will print out automatically when the
problem is fixed.
FILM END
The imaging film may need replacement. Check
the film and replace it if necessary.
FUNCTION MODE
The
FUNCTION
key has been pressed.
LINE ERROR
Transmission or reception was not successful.
Press
STOP
to clear the message, and then try
again.
LINE IS IN USE
An extension phone connected to the fax is
being used. Do not lift the fax’s handset or
attempt transmission at this time, as this will
interrupt the conversation on the extension
phone.
MEMORY IS FULL The memory is full. See "Memory" in Chapter 7.
MEMORY PRINTING
The fax is preparing to or printing out a
document from memory.
ON HOOK DIAL
The
SPEAKER
key has been pressed and the
fax is waiting for you to dial.
OUT OF PAPER You are out of printing paper.
OVER HEAT
The print head has overheated. Operation can
be continued once it cools.
PAPER JAMMED
The printing paper is jammed. See the following
section, "Clearing Paper Jams".
Note: If you have turned on the Caller ID function, see "Caller ID" in Chapter 7 for
display messages related to Caller ID.
TROUBLESHOOTING 11-3