Filter
Top Products
3-21
Setup and Installation: Communication
Saving Changes
Exiting the MK1000 Configuration menu via the Save & Reboot option saves any changes
made. Changes made while navigating the MK1000 Configuration screens are NOT saved
or applied UNLESS the MK1000 Configuration menu is exited through its Save & Reboot
option. Upon exiting in this manner, the unit reboots and applies the changes.
If the MK1000 Configuration menu is exited by pressing the ‘1’ button (Escape), changes
will NOT be saved and the original settings are retained.
To save changes:
1. Access the MK1000 Configuration menu.
2. Press the Previous or Next buttons to move the "<" cursor to the Save & Reboot
option.
3. Press the Enter button to save changes and reboot.
Entering Alphanumeric Values
To enter alphanumeric values when you want to change the contents of a field, such as an
IP address:
1. Select the field using Previous and Next buttons.
2. Press the Enter button (i.e., button ‘4’) to enter "scroll-edit" mode. The field clears,
and the first character of the field displays. For instance, when changing an IP
address, the field is cleared and a zero ("0") displays at the first position with a
blinking line under it.
3. Press the Previous and Next buttons to rotate through all possible values (0-9, ".").
4. When you reach the desired value, press the Enter button to lock it in and move to
the next position.
5. If the desired value is entered into a position and you are finished data entry, press
the Escape button to leave scroll-edit mode.
6. Press Enter to make the change permanent. The "<" cursor points to the field you
just changed.
7. Press the Escape button to return to the main menu.
8. Select Save & Reboot to save your changes.
Note:If you enter an incorrect value in a numeric data field (e.g., IP
address) and want to start over, press the ‘1’ button (Escape) twice
to replace the original data.