Filter
Top Products
3-41
Setup and Installation: Communication
Table 3-17. Laser Scanner Config Screen Definitions
Field Name Description
Driver Press the Previous or Next buttons to move the "<"
cursor to this field and toggle by pressing the Enter
button to enable or disable the scanner driver.
If the driver is disabled then the scanner is not
initialized and it becomes possible for a user
application to communicate with the scanner
directly using the appropriate Com driver (i.e.,
C_SID_IO_UART2).
The default laser scanner driver setting for the
MK1000 is ENABLED.
Scan Mode Press the Previous or Next buttons to move the "<"
cursor to this field and toggle by pressing the Enter
button to select the scan mode.
The default scan mode for the MK1000 is
CYCLONE. (See Appendix C, Scanning Mode
Programming Bar Codes for a list of the scan
modes.)
Beeper Press the Previous or Next buttons to move the "<"
cursor to this field and toggle by pressing the Enter
button to enable or disable the MK1000 beeper.
When enabled, a beep sounds upon a successful
decode.
The default beeper setting for the MK1000 is
DISABLED.