TANDBERG D14049.04 Network Card User Manual


  Open as PDF
of 276
 
251
D14049.04
JULY 2008
Grey Headline (continued)
SubZoneAdd
Adds and congures a new subzone.
SubZoneName(r): <S: 1, 50>
Assigns a name to this subzone.
Address: <S: 0, 39>
Species an IP Address used (in conjunction with the IP Prex Length) to identify a subnet to be assigned to this subzone.
PrexLength: <0..128>
Species the number of bits of the Subnet IP Address which must match for an IP Address to belong in this subzone.
TotalMode: <Unlimited/Limited/NoBandwidth>
Determines whether the Default Subzone has a limit on the total bandwidth being used by its endpoints at any one time. NoBandwidth: no bandwidth available. No calls can be made
to, from, or within the Default Subzone. Default: Unlimited.
Total: <1..100000000>
Sets the total bandwidth limit (in kbps) of the Default Subzone (applies only if Mode is set to Limited). Default: 500000.
PerCallInterMode: <Unlimited/Limited/NoBandwidth>
Determines whether there is a limit on the bandwidth for any one call to or from an endpoint in this subzone. NoBandwidth: no bandwidth available. No calls can be made to or from
this subzone. Default: Unlimited.
PerCallInter: <1..100000000>
Species the bandwidth limit (in kbps) on any one call to or from an endpoint in this subzone (applies only if Mode is set to Limited). Default: 1920.
PerCallIntraMode: <Unlimited/Limited/NoBandwidth>
Determines whether there is a limit on the bandwidth for any one call between two endpoints within this subzone. NoBandwidth: no bandwidth available. No calls can be made within
this subzone. Default: Unlimited.
PerCallIntra: <1..100000000>
Species the bandwidth limit (in kbps) for any one call between two endpoints within this subzone (applies only if Mode is set to Limited). Default: 1920.
Example: xCommand SubZoneAdd SubZoneName: "BranchOfce" Address: "10.13.0.0" PrexLength: 28 TotalMode: Limited Total: 1024 PerCallInterMode:
Limited PerCallInter: 512 PerCallIntraMode: Limited PerCallIntra: 512
SubZoneDelete
Deletes a subzone.
SubZoneId(r): <1..100>
The index of the subzone to be deleted.
Example: xCommand SubZoneDelete SubZoneId:2
TANDBERG VIDEO COMMUNICATIONS SERVER
ADMINISTRATOR GUIDE
Introduction Getting Started
Overview and
Status
System
Conguration
VCS
Conguration
Zones and
Neighbors
Call
Processing
Bandwidth
Control
Firewall
Traversal
Appendices
Applications Maintenance
Command Reference - xCommand
 previous next