Filter
Top Products
117
Select the delay to be applied to audio relative to
video.
A setting used only to rectify some types of 'lip
sync' issues sometimes found with certain
endpoints. Leave at default setting, unless advised
to alter it by Codian technical support or a
reseller.
Controls whether connected endpoints are
allowed to use floor and chair control operations.
This option acts as a unit-wide control over
whether any H.243 floor and chair control
operations are permitted. Individual conferences
may have their own floor and chair control
policies set; however, if this setting is Disabled
then no floor or chair control operations will be
possible within conferences. Changing this setting
will only affect new calls - existing calls will
continue with the setting in force when they
became active.
For more information, refer to H.243 floor and
chair control.
Sets the default action when endpoints call into
the MCU using an unknown E.164 number; i.e.
one the does not correspond to any configured
conference.
The endpoint will enter the default auto
attendant from which they may join
existing conferences or potentially
create a new conference (see Using an
auto attendant). This behavior is the
same as if the endpoint had called the
MCU using its IP address rather than an
E.164 number.
Endpoints are not allowed to call
unknown E.164 numbers, and the call
will be terminated.
A new conference will be created with
the E.164 number called as its numeric
identifier. The endpoint automatically
joins this new conference. This option is
not available if the MCU is in port
reservation mode.
This option can make it easier for callers to create
ad hoc conferences if Create new conference is
selected. If you do not wish callers to be able to
create conferences in this way, select one of the
other options.
When enabled, if the MCU is calling out to an
H.323 endpoint, the caller ID that the endpoint
will see is the conference name.
Without this option selected, the caller ID is the
name of the MCU.
Instructs the MCU to request conference
participants dialing into protected conferences
using an E.164 number via an H.323 gatekeeper
to enter a PIN before they may join the
You may wish participants joining a conference
via a gatekeeper not to need to enter a PIN, even
for protected conferences. If this is the case, do
not set this option. If you wish conferences to be