Filter
Top Products
159
The Health Status displays information about the hardware components of the MCU. To access this information, go
to
Note that the Worst status seen conditions are those since the last time the unit was restarted.
To reset these values, click . Refer to the table below for assistance in interpreting the information displayed.
Displays two possible states:
OK
Out of spec
States indicate both and
conditions.
– component is functioning properly
– Check with your support
provider; component might require
service
If the column displays "Out of
spec", but is "OK", monitor the
status regularly to verify that it was only a
temporary condition.
Displays three possible states:
OK
Out of spec
Critical
States indicate both and
conditions.
– temperature of the MCU is within
the appropriate range
– Check the ambient
temperature (should be less than 34
degrees Celsius) and verify that the air
vents are not blocked
– temperature of MCU is too
high. An error also appears in the event
log indicating that the system will
shutdown in 60 seconds if the condition
persists
If the column displays "Out of
spec", but is "OK", monitor the
status regularly to verify that it was only a
temporary condition.