Filter
Top Products
87
Choose whether to use the unit-wide setting for
motion/sharpness trade off, or configure an
individual setting for use with this endpoint.
Choose from:
<use box-wide setting>: this is the default
value. In this case, the connection to the
endpoint will use the motion /
sharpness tradeoff setting from the
page.
Favor motion: the MCU will try and use a
high frame rate. That is, the MCU will
strongly favor a resolution of at least 25
frames per second
Favor sharpness: the MCU will use the
highest resolution that is appropriate for
what is being viewed
Balanced: the MCU will select settings
that balance resolution and frame rate
(where the frame rate will not be less
than 12 frames per second)
The settings for motion (frames per second) and
sharpness (frame size or resolution) are
negotiated between the endpoint and the MCU.
This setting controls how the MCU will negotiate
the settings to be used with this endpoint.
Choose the setting for transmitted video
resolutions from the MCU to this endpoint. This
setting overrides the unit-wide setting on the
page
Retain the default setting (use box-wide setting)
unless you are experiencing problems with the
display of certain resolutions by this endpoint.
Endpoints advertise the resolutions that they are
able to display. The MCU then chooses from
those advertised resolutions, the resolution that it
will use to transmit video. However, some
endpoints do not display widescreen resolutions
optimally. Therefore, you might want to use this
setting to restrict the resolutions available to the
MCU for transmissions to this endpoint.
Whether this endpoint is permitted to contribute
the conference content channel. Choose from:
<use conference default>: this endpoint will use the
Content contribution from endpoints setting from the
per-conference configuration.
Enabled: This endpoint is allowed to contribute
the content channel, even if content contribution
from endpoints is disabled in the per-conference
configuration.
Disabled: This endpoint is not allowed to
contribute the conference channel, even if
content contribution from endpoints is enabled in
the per-conference configuration.
This setting is provided to allow you to
individually configure whether or not an
endpoint is allowed to contribute content to a
conference.
To use the content channel, the Content status
must be enabled at the unit-wide level (on the
page) and for any given
conference Content channel video must also be
enabled in the per-conference configuration.