Filter
Top Products
62
Content is enabled for this conference, but this
participant is not allowed to receive it. To enable
content for this participant, configure the Content
video receive setting for this participant's endpoint
(refer to Configuring H.323 endpoints), or use
the enable control for an active call.
There is a unit-wide setting that determines
which video codec is used by the MCU for
outgoing content channels. The Outgoing content
video codec is on the page.
This message means that the endpoint is able to
receive content video, but not using the same
codec as the MCU is configured to transmit.
For each conference, the MCU uses a single video
stream for all outgoing content connections to
endpoints. This entails considering all endpoints'
receive capabilities and deciding which resolution
and bit rate to send in order to maximize the
number of content channel viewers. These
messages mean that the MCU has been unable to
include this endpoint in the set of content viewers
because of its limitations with regard to format
(video resolution) or bit rate. Note that it is
possible to configure a lower limit on the
bandwidth of the shared content video encoding
which will cause a bit rate mismatch where an
endpoint is only able to receive a low bit rate
stream (refer to Configuring content settings).
The MCU supports only presentation mode for its
content channels; specifically, H.239 live mode is
not supported. This status message indicates that
the endpoint is content-capable but does not
support presentation mode.
The MCU is unable to send encrypted content
video to this participant.
The MCU has detected that the content link to
this endpoint is experiencing problems, and has