Filter
Top Products
Line Painter 1200Gasoline Engine Page 3 – 8
Engine
Figure 5
1. Engine
2. Oil drain valve
3. O–ring
4. Drain extension
5. Screw (6 used)
6. Washer head screw (2 used)
7. Nut (2 used)
8. Frame
9. Fuel tank support
10. Washer head screw (2 used)
11. Fuel tank cap
12. Fuel tank
13. Fuel tank bracket
14. Hose clamp (4 used)
15. Fuel hose
16. Fuel shut off valve
17. Fuel hose
18. Engine pulley
19. Cap screw
FRONT
RIGHT
13
12
9
11
5
7
8
6
4
3
2
17
16
1
14
15
10
3
14
14
14
18
19
50 to 60 ft–lb
(68 to 81 N–m)
20 to 30 ft–lb
(27 to 41 N–m)
250 to 450 in–lb
(28 to 51 N–m)
5
Loctite #242
Removal (Fig. 5)
1. Park machine on a level surface, stop engine, en-
gage parking brake and remove key from the ignition
switch. Remove high tension lead from the spark plug
and position the lead away from the spark plug.
2. If engine is to be disassembled, it may be easier to
drain oil from engine before removing engine from ma-
chine (see Operator’s Manual).
3. Close fuel shut off valve. Disconnect fuel hose from
carburetor inlet.
4. Remove fuel tank from machine (see Fuel Tank Re-
moval in this section).
5. If machine is equipped with a hour meter, remove
hour meter pickup wire from spark plug lead on engine.
Position pickup wire away from engine.
6. Disconnect stop switch wire from engine (Fig. 6).
Make sure that ground wire is removed from fuel tank
bracket (item 14).