Filter
Top Products
Adjustments
Traction Drive Cable
1. Park machine on a level surface, stop engine, en-
gage parking brake and remove key from the ignition
switch. Remove high tension lead from the spark plug
and position the lead away from the spark plug.
2. Make sure that traction lever on handle is released.
3. Adjust location of traction cable jam nuts so that trac-
tion cable spring is stretched .120” to .250” (3.0 to 6.4
mm) from it’s relaxed state.
4. Make sure that jam nuts are fully tightened and that
boot is positioned on end of traction cable.
5. Secure high tension lead to spark plug.
1
2
3
3
4
5
Figure 1
1. Traction drive cable 4. Cable spring
2. Idler bracket 5. Cable boot
3. Jam nut
Line Painter 1200 Page 6 – 3 Chassis and Controls
Chassis and
Controls