Filter
Top Products
Line Painter 1200Chassis and Controls Page 6 – 12
Traction Drive Cable
1. Traction lever
2. Flat washer
3. Cap screw
4. Flange bushing
5. Traction drive cable
6. Hair pin
7. Flange nut
8. Bushing (2 used)
9. Bushing
10. Castor release lever
Figure 11
2
3
4
1
5
6
7
8
10
9
4
Removal (Fig. 11)
1. Park machine on a level surface, stop engine, en-
gage parking brake and remove key from the ignition
switch. Remove high tension lead from the spark plug
and position the lead away from the spark plug.
2. Disconnect traction drive cable from traction lever on
machine handle:
A. Loosen jam nut that secures cable to handle as-
sembly.
B. Remove hair pin that retains cable end to traction
lever.
C. Slide cable end from traction lever.
3. Disconnect traction drive cable from traction idler
bracket under machine (Fig. 12):
A. Loosen jam nuts that secure cable to chassis
bracket.
B. Disconnect cable spring from idler bracket.
4. Note routing of traction drive cable. Remove cable
from machine.
Installation (Fig. 11)
1. Position traction drive cable to machine.