Toshiba 1600XP Power Supply User Manual


  Open as PDF
of 90
 
11
1600XP Series Installation and Operation Manual
P/N 48518 – Battery terminals can deliver
dangerous electrical shock. Service by
qualied service representatives only.
WARNING
This unit contains sealed lead acid batteries.
Lack of preventative maintenance could result
in batteries exploding and emitting gasses and/or
flame. Annual preventative maintenance must be
performed by an authorized, trained technician.
WARNING
CRITICAL FUSE SIZING
Incorrect fuse replacement size
may result in fire or inadequate
equipment protection.
Replace only with same type
and rating of fuse.
49455 SHEET
CAUTIO N/
ATTEN TIO N
Do not disconnect
whi le uni t is
operating
on battery power.
Nes pas debrancher
sous charge.
48524 SHEET
Risk of electric shock. Do not remove cover.
. Refer servicing to qualified service personnel.
NO U S E R S E RVICEABL E PARTS
INSIDE
To reduce the risk of fire or electric shock, install in a temperature and
humidity controlled indoor area free of conductive contaminants.
En cas utilisation en atmosphere controlee. Consulter la notice technique.
Note: Service personnel only.
Hazardous live parts inside the UPS are energized from the battery supply
even when the input AC power is disconnected.
Capacitors store hazardous energy. Do not remove cover until 5 minutes
after disconnecting all sources of supply.
Battery backup time, which was factory-set at a predetermined level,
decreases gradually between service periods. The batteries should be
replaced every three years after the last servicing, the date of which is
written on the ID plate located on the rear side of the UPS unit, or in the
boxes below.
Date of last battery charge:
WARNING
CAUTION
Do not insert batte ry trays with the power off !
Th is uni t is desi gned for ho t chan geable batteries!
When i nstalli ng batteries, the UPS must b e i n th e
online or bypass mode. Contact Toshiba
International Corporation for further details.
60412
PN 51727
EXTERNAL BATTERY CABINET
The battery cabinet must have
a nominal battery voltage of
288VDC.
WARNING
DANGER/ATTENTION
Risk of electrical shock. Do not touch uninsulated
battery terminals. Batteries should be serviced by
qualified service representative only. Miswiring of
battery could result in electrcal shock and/or fire.
Risque de choc electrique. Le circuit des batteries
nest pas esolede secteur. Les cosses des batteries
peuvent presenter une tension dangereuse part
rapport a la terre. Verifier avant de toucher.
DANGER
Battery fuse is always
live. Risk of electrical
shock. Check fuse
voltage and disconnect
external batteries
before changing fuse.
48518 SHEET
fig 1
fig 2
1
2
3
Unpacking Instructions
P/N 48537
TYPEFORM
OUTPUT
MFD. IN U.S.A. FROM FOREIGN AND DOMESTIC COMPONENTS
HOUSTON, TEXAS
UNINTERRUPTIBLE POWER SUPPLY
INPUT
SERIAL NO.
PN 60381
LISTED
POWER
SUPPLY
27E5
C US
EPO
14
15
16
17
EPO1
EPO2
REMOTE
REMO TE
1
L1
L2 G
X1 X2
208V
120V
120V
20 8/2 40V
OUTP UT
INPU T
N
X3
G
208V
USE COPPER 90 CONDUCTORS ONLY. REFER TO INSTRUCTION MANUAL REGARDING TIGHTENING TORQUE OF TERMINAL BLOCKS. FACTORY WIRED FOR 208V INPUT.
C OM
2
3
4
5
6 7
8
11
12
13
240V
240V
REMOTE
JUMPER SELECTION
50802
P/N 49455 – UPS Batteries require an-
nual preventative maintenance. Failure to
perform regular maintenance could result in
batteries exploding, or emitting gasses or
ame.
WARNING
This unit contains sealed lead acid batteries.
Lack of preventative maintenance could result
in batteries exploding and emitting gasses and/or
flame. Annual preventative maintenance must be
performed by an authorized, trained technician.
WARNING
CRITICAL FUSE SIZING
Incorrect fuse replacement size
may result in fire or inadequate
equipment protection.
Replace only with same type
and rating of fuse.
49455 SHEET
CAUTION/
ATTEN TI O N
Do not disco nnect
whi le uni t is
operating
on battery power.
Nes pas debrancher
sou s charg e.
48524 SHEET
Risk of electric shock. Do not remove cover.
. Refer servicing to qualified service personnel.
NO US ER SER VICEABLE PARTS
IN SIDE
To reduce the risk of fire or electric shock, install in a temperature and
humidity controlled indoor area free of conductive contaminants.
En cas utilisation en atmosphere controlee. Consulter la notice technique.
Note: Service personnel only.
Hazardous live parts inside the UPS are energized from the battery supply
even when the input AC power is disconnected.
Capacitors store hazardous energy. Do not remove cover until 5 minutes
after disconnecting all sources of supply.
Battery backup time, which was factory-set at a predetermined level,
decreases gradually between service periods. The batteries should be
replaced every three years after the last servicing, the date of which is
written on the ID plate located on the rear side of the UPS unit, or in the
boxes below.
Date of last battery charge:
WARNING
CAUTION
Do not insert ba tte ry trays with the power off !
Th is unit is desi gned f or hot chan ge able bat t er ies!
When installing batteries, the UPS must be in the
online or bypass mode. Contact Toshiba
International Corporation for further details.
60412
PN 51727
EXTERNAL BATTERY CABINET
The battery cabinet must have
a nominal battery voltage of
288VDC.
WARNING
DANGER/ATTENTION
Risk of electrical shock. Do not touch uninsulated
battery terminals. Batteries should be serviced by
qualified service representative only. Miswiring of
battery could result in electrcal shock and/or fire.
Risque de choc electrique. Le circuit des batteries
nest pas esolede secteur. Les cosses des batteries
peuvent presenter une tension dangereuse part
rapport a la terre. Verifier avant de toucher.
DANGER
Battery fuse is always
live. Risk of electrical
shock. Check fuse
voltage and disconnect
external batteries
before changing fuse.
48518 SHEET
fig 1
fig 2
1
2
3
Unpacking Instructions
P/N 48537
TYPEFORM
OUTPUT
MFD. IN U.S.A. FROM FOREIGN AND DOMESTIC COMPONENTS
HOUSTON, TEXAS
UNINTERRUPTIBLE POWER SUPPLY
INPUT
SERIAL NO.
PN 60381
LISTED
POWER
SUPPLY
27E5
C US
EPO
14
15
16
17
EPO1
EPO2
REMOTE
REM O TE
1
L1
L2 G
X1 X2
208V
120V
120V
20 8/ 240 V
OUTPUT
INPUT
N
X3
G
208V
USE COPPER 90 CONDUCTORS ONLY. REFER TO INSTRUCTION MANUAL REGARDING TIGHTENING TORQUE OF TERMINAL BLOCKS. FACTORY WIRED FOR 208V INPUT.
C OM
2
3
4
5
6 7
8
11
12
13
240V
240V
REMOTE
JUMPER SELECTION
50802
P/N 49455 – Replace Fuse only
with one of same type and range.
Incorrect fuse size may result in
equipment damage.
WARNING
This unit contains sealed lead acid batteries.
Lack of preventative maintenance could result
in batteries exploding and emitting gasses and/or
flame. Annual preventative maintenance must be
performed by an authorized, trained technician.
WARNING
CRITICAL FUSE SIZING
Incorrect fuse replacement size
may result in fire or inadequate
equipment protection.
Replace only with same type
and rating of fuse.
49455 SHEET
CAUTIO N/
ATTEN TIO N
Do not disconnect
whi le uni t is
operating
on battery power.
Nes pas debrancher
sous charge.
48524 SHEET
Risk of electric shock. Do not remove cover.
. Refer servicing to qualified service personnel.
NO U S E R S E RVICEABL E PARTS
INSIDE
To reduce the risk of fire or electric shock, install in a temperature and
humidity controlled indoor area free of conductive contaminants.
En cas utilisation en atmosphere controlee. Consulter la notice technique.
Note: Service personnel only.
Hazardous live parts inside the UPS are energized from the battery supply
even when the input AC power is disconnected.
Capacitors store hazardous energy. Do not remove cover until 5 minutes
after disconnecting all sources of supply.
Battery backup time, which was factory-set at a predetermined level,
decreases gradually between service periods. The batteries should be
replaced every three years after the last servicing, the date of which is
written on the ID plate located on the rear side of the UPS unit, or in the
boxes below.
Date of last battery charge:
WARNING
CAUTION
Do not insert batte ry trays with the power off !
Th is uni t is desi gned for ho t chan geable batteries!
When i nstalli ng batteries, the UPS must b e i n th e
online or bypass mode. Contact Toshiba
International Corporation for further details.
60412
PN 51727
EXTERNAL BATTERY CABINET
The battery cabinet must have
a nominal battery voltage of
288VDC.
WARNING
DANGER/ATTENTION
Risk of electrical shock. Do not touch uninsulated
battery terminals. Batteries should be serviced by
qualified service representative only. Miswiring of
battery could result in electrcal shock and/or fire.
Risque de choc electrique. Le circuit des batteries
nest pas esolede secteur. Les cosses des batteries
peuvent presenter une tension dangereuse part
rapport a la terre. Verifier avant de toucher.
DANGER
Battery fuse is always
live. Risk of electrical
shock. Check fuse
voltage and disconnect
external batteries
before changing fuse.
48518 SHEET
fig 1
fig 2
1
2
3
Unpacking Instructions
P/N 48537
TYPEFORM
OUTPUT
MFD. IN U.S.A. FROM FOREIGN AND DOMESTIC COMPONENTS
HOUSTON, TEXAS
UNINTERRUPTIBLE POWER SUPPLY
INPUT
SERIAL NO.
PN 60381
LISTED
POWER
SUPPLY
27E5
C US
EPO
14
15
16
17
EPO1
EPO2
REMOTE
REMO TE
1
L1
L2 G
X1 X2
208V
120V
120V
20 8/2 40V
OUTP UT
INPU T
N
X3
G
208V
USE COPPER 90 CONDUCTORS ONLY. REFER TO INSTRUCTION MANUAL REGARDING TIGHTENING TORQUE OF TERMINAL BLOCKS. FACTORY WIRED FOR 208V INPUT.
C OM
2
3
4
5
6 7
8
11
12
13
240V
240V
REMOTE
JUMPER SELECTION
50802
Safety Label Explanations
P/N 63094 – External warning sign.
Unit contains potentially dangerous voltages. •
Read the instruction manual before operating. •
There are no user serviceable parts inside. •
Refer service to qualied personnel.
Do not open the cover while power is applied, •
or within ve minutes after removal of power.
Potentially hazardous leakage current may •
exist. Ensure the grounding is connected
before connecting the utility power..
 previous next