Filter
Top Products
© June 2005 TOSHIBA TECe-STUDIO281c/351c/451c ERROR CODE AND SELF-DIAGNOSTIC MODE
2 - 1
2
2.ERROR CODE AND SELF-DIAGNOSTIC MODE
2.1Error Code List
2.1.1Jam
The following error codes is displayed at the upper right of the screen when the CLEAR PAPER! or CALL
SERVICE! symbol is blinking.
Error codeClassificationContentsTroubleshooting
E010Paper exit jamJam not reaching the exit sensor : The paper which
has passed through the fuser unit does not reach
the exit sensor.
P. 5-1
E020Paper exit jamStop jam at the exit sensor: The trailing edge of the
paper does not pass the exit sensor after its leading
edge has reached this sensor.
P. 5-2
E030Other paper jamPower-ON jam: The paper is remaining on the
paper transport path when power is turned ON.
P. 5-18
E061Incorrect paper size setting for upper drawer: The
size of paper in the 1st drawer differs from size set-
ting of the equipment.
P. 5-18
E062Incorrect paper size setting for lower drawer: The
size of paper in the 2nd drawer differs from size set-
ting of the equipment.
P. 5-18
E063Incorrect paper size setting for PFP upper drawer:
The size of paper in the 3rd drawer differs from size
setting of the equipment.
P. 5-18
E064Incorrect paper size setting for PFP lower drawer:
The size of paper in the 4th drawer differs from size
setting of the equipment.
P. 5-18
E065Incorrect paper size setting for bypass tray: The
size of paper in the bypass tray differs from size
setting of the equipment.
P. 5-18
E090Image data delay jam: Image data to be printed
cannot be prepared.
P. 5-19