Filter
Top Products
e-STUDIO281c/351c/451c ERROR CODE AND SELF-DIAGNOSTIC MODE© June 2005 TOSHIBA TEC
2 - 6
EA80Finisher jam
(Saddle stitcher sec-
tion)
Stapling jam: Stapling is not performed properly.
[MJ-1024]
P. 5-43
EA90Door open jam: The delivery cover or inlet cover
has opened dur-ing printing [MJ-1024].
P. 5-43
EAA0Power-ON jam: Paper exists at No.1 paper sensor,
No. 2 paper sensor, No.3 paper sensor, vertical
path paper sensor or delivery sensor when power is
turned ON. [MJ-1024]
P. 5-44
EAB0Transport stop jam: The paper which passed
through the inlet sensor does not reach or pass
No.1 paper sensor, No. 2 paper sensor, No.3 paper
sensor or delivery sensor. [MJ-1024]
P. 5-44
EAC0Transport delay jam: The paper which has reached
the inlet sensor does not pass through the inlet sen-
sor. [MJ-1024]
P. 5-45
EAD0Other paper jamPrint end command time-out jam: The printing has
not finished normally because of the communica-
tion error between the SYS board and LGC board
at the end of printing.
P. 5-47
EAE0Finisher jamReceiving time time-out jam: The printing has been
interrupted because of the communication error
between the equipment and finisher when the
paper is transported from the equipment to the fin-
isher.
P. 5-47
EAF0Finisher jam
(Finisher section)
Stack return jam: It cannot load the paper which
passed through the delivery roller on the intermedi-
ary process tray. [MJ-1022]
P. 5-42
EB30Finisher jamReady time time-out jam: The equipment judges
that the paper transport to the finisher is disabled
because of the communication error between the
equipment and finisher at the start of printing.
P. 5-47
EB50Paper transport jamPaper remaining on the transport path: The multiple
feeding of preceding paper caused the misfeeding
of upcoming paper.
P. 5-16
EB60Paper remaining on the transport path: The multiple
feeding of preceding paper caused the misfeeding
of upcoming paper (redetection after no jam is
detected at [EB50]).
P. 5-17
ED10Finisher jamSideways adjustment motor (M2) home position
detection error: The Sideways adjustment motor is
not at the home position. [MJ-1101 (when MJ-6101
is installed)]
P. 5-48
ED11Skew adjustment motor (M1) home position detec-
tion abnormality: The Skew adjustment motor is not
at the home position. [MJ-1101 (when MJ-6101 is
installed)]
P. 5-48
ED12Shutter home position error: The shutter is not at
the home position. [MJ-1101]
P. 5-49
ED13Front alignment plate home position error: The front
alignment plate is not at the home position. [MJ-
1101]
P. 5-49
ED14Rear alignment plate home position error: The rear
alignment plate is not at the home position. [MJ-
1101]
P. 5-50
ED15Paddle home position error: The paddle is not at the
home position. [MJ-1101]
P. 5-50
ED16Buffer tray home position error: The buffer tray is
not at the home position. [MJ-1101]
P. 5-51
Error codeClassificationContentsTroubleshooting
06/08