Filter
Top Products
e-STUDIO281c/351c/451c ERROR CODE AND SELF-DIAGNOSTIC MODE© June 2005 TOSHIBA TEC
2 - 4
E550Other paper jamPaper remaining jam on the transport path: The
paper is remaining on the transport path when print-
ing is finished (caused by a multiple paper feeding).
P. 5-19
E712RADF jamJam not reaching the original registration sensor:
The original fed from the original feeding tray does
not reach the original registration sensor.
P. 5-24
E713Cover open jam in the read ready status: Jam
caused by opening of the RADF jam access cover
or front cover while the RADF is waiting for the
scanning start signal from the equipment.
P. 5-24
E714Feed signal reception jam: The feed signal is
received even no original exists on the original
feeding tray.
P. 5-25
E721Jam not reaching the read sensor: The original
does not reach the read sensor after it has passed
the registration sensor (when scanning obverse
side) or the reverse sensor (when scanning reverse
side).
P. 5-25
E722Jam not reaching the original exit/reverse sensor
(during scanning): The original which passed the
read sensor does not reach the original exit/reverse
sensor when it is transported from the scanning
section to exit section.
P. 5-26
E724Stop jam at the original registration sensor: The
trailing edge of the original does not pass the origi-
nal registration sensor after its leading edge has
reached this sensor.
P. 5-26
E725Stop jam at the read sensor: The trailing edge of the
original does not pass the read sensor after its lead-
ing edge has reached this sensor.
P. 5-27
E731Stop jam at the original exit/reverse sensor: The
trailing edge of the original does not pass the origi-
nal exit/reverse sensor after its leading edge has
reached this sensor.
P. 5-27
E860RADF jam access cover open: The RADF jam
access cover has opened during RADF operation.
P. 5-27
E870RADF open jam: RADF has opened during RADF
operation.
P. 5-28
E910Finisher jam
(Bridge unit)
Jam at the bridge unit transport sensor 1: The
paper does not reach the bridge unit transport sen-
sor 1 after it has passed the exit sensor.
P. 5-29
E920Stop jam at the bridge unit transport sensor 1: The
trailing edge of the paper does not pass the bridge
unit transport sensor 1 after its leading edge has
reached the sensor.
P. 5-29
E930Jam at the bridge unit transport sensor 2: The trail-
ing edge of the paper does not reach the bridge unit
transport sensor 2 after its leading edge has
reached the bridge unit transport sensor 1.
P. 5-29
E940Stop jam at the bridge unit transport sensor 2: The
trailing edge of the paper does not pass the bridge
unit transport sensor 2 after its leading edge has
reached the bridge unit transport sensor 2.
P. 5-29
E9F0Finisher jam
(Punch unit)
Punching jam: Punching is not performed properly.
[MJ-1023/1024 (when MJ-6004 is installed)]
[MJ-1101 (when MJ-6101 is installed)]
P. 5-46
Error codeClassificationContentsTroubleshooting
06/08