Filter
Top Products
2. PRINTER SETUP ENGLISH VERSION EO1-33089
2.3 Loading Supplies
E2- 6
2.3.1 Loading the Media
(Cont.)
7. Align the projection of the Supply Holder with the groove of the
Supply Shaft, and push the Supply Holder against the media until the
media is held firmly in place. This will centre the media
automatically.
Then turn the Locking Ring clockwise to secure the Supply Holder.
8. Place the media between the Media Guides, adjust the Media Guides
to the media width, and tighten the Locking Screw.
9. Check that the media path through the printer is straight. The media
should be centred under the Print Head.
NOTE:
D
o not ove
r
-tighten the Lockin
g
R
ing of the Supply Holder.
Media Guide
Supply Holder
Media Guide
Print Head
Locking Screw
Media
Guide Shaft
Media
In the case of a label rolled wit
h
the print side facing inside.
In the case of a label rolled with
the print side facing outside.
Projection
Locking Ring
Supply Holder
Guide Shaft
Groove
Supply Shaft