Filter
Top Products
2. PRINTER SETUP ENGLISH VERSION EO1-33089
2.6 Printer Setting
E2-21
2.6.2 Parameter Setting
(Cont.)
(11) WEB PRINTER
This parameter is to choose whether to use the printer as a web printer.
When the web printer is enabled, the status of the printer connected to
a network can be monitored through the web browser.
• OFF Disables web printer function
• ON INTERNAL Enables web printer function (using an internal
memory)
• ON EXTERNAL Enables web printer function (using an external
memory)
(12) RBN NEAR END
This parameter is to choose the remaining ribbon length where the
ribbon near end is detected.
• OFF Ribbon near end is not detected.
• 30m Ribbon near end is detected when the remaining
ribbon is 30-m long. (Equivalent to ribbon diameter
of 38 mm)
• 70m Ribbon near end is detected when the remaining
ribbon is 70-m long. (Equivalent to ribbon diameter
of 43 mm)
(13) EX.I/O
This parameter is to choose a type of the expansion I/O interface
operating mode. This parameter needs to be set depending on the
expansion I/O control specification of the device to be connected via
the expansion I/O interface.
• TYPE1 Standard mode
• TYPE2 In-line mode
(14) LBL/RBN END
This parameter is to choose a printer processing when a label end or
ribbon end is detected.
• TYPE1 When a label/ribbon end is detected in the middle of
printing, the printer immediately stops printing.
• TYPE2 Selectable only when the ribbon saving function is
not activated.
When a label/ribbon end is detected in the middle of
printing, the printer prints the half-finished label as
far as possible, and stops when the next label is at the
home position.
(15) MAXI CODE
This parameter is to choose a Maxicode specification.
• TYPE1 Compatible with the current version
• TYPE2 Special specification
NOTE:
The type specified by the
command may differ from the
actual mode, depending on the
status of this parameter. Also,
the data transmission method
differs partly.
F
or details, refer to the External
E
quipment Interface
Specification.
NOTE:
Since a detected remaining
ribbon length has some margin of
error, use the specified length as
a guide.