Filter
Top Products
2. PRINTER SETUP ENGLISH VERSION EO1-33089
2.6 Printer Setting
E2-26
2.6.6 Automatic Calibration
The Auto Calibration menu allows selecting whether or not to enable the
automatic calibration at a power on time. When the automatic calibration
is activate, the printer feeds the media for about 160 mm each time the
power is turned on or the top cover is opened, to detect a print start
position.
(1) AUTO CALIB
• OFF Disabled.
• ON TRANS. Enabled. (Transmissive sensor)
• ON REFLECT Enabled. (Reflective sensor)
• ON ALL Enabled. (Transmissive & Reflective
sensors)
• ON TRANS.+Bfeed Auto calibration + back feed
(Transmissive sensor)
• ON REFLECT+Bfeed Auto calibration + back feed
(Reflective sensor)
• ON ALL+Bfeed Auto calibration + back feed
(Transmissive & Reflective sensors)
NOTES:
1. When AUTO CALIB is enabled, an automatic calibration is performed at
an open/close of the print head and at a power on time.
2. When AUTO CALIB is enabled, the media length, effective print length,
sensor type, and whether to use ribbon or not specified by commands are
ignored.
3. This function is available only when the media pitch is 10.0 mm to 150.0
mm.
4. When the printer cannot detect the second black mark/gap, it will
continue to feed the media for up to 500.0mm. If this does not work, the
printer will stop, resulting in a paper jam.
5. During an automatic calibration, the printer also feeds the ribbon. Even
if the ribbon is not loaded, no error results. However, the print condition
will be automatically changed to “No ribbon” after the calibration ends.
6. When the cutter is installed and a previous issue was performed in cut
issue mode, the media is cut and ejected after an automatic calibration
completes.
7. When a label end or a head open occurs during an automatic calibration,
the printer stops, resulting in an error. Loading new media and closing
the print head can clear the error and resume the automatic calibration.
8. The media is fed backward after an auto calibration is performed if the
reverse feed is enabled.
USER SYSTEM MODE
<4>LAN/WLAN
<5>BASIC
<6>Z-MODE
<7>AUTO CALIB