Filter
Top Products
2. PRINTER SETUP ENGLISH VERSION EO1-33089
2.6 Printer Setting
E2-18
2.6.2 Parameter Setting
(Cont.)
(5) HU CUT/RWD.
This parameter is to choose whether or not to activate the head up
action in the cut issue or to use the Rewinder in the batch or strip issue.
This function prevents ribbon smudges by raising the print head
during a reverse feed to the print start position.
• OFF Head up cut is not performed or the Rewinder is not
used.
• ON Head up cut is performed or the Rewinder is used.
(6) RBN SAVE
This parameter is to choose whether or not to activate the ribbon
saving function. This function enables reducing the ribbon loss
caused by taking up unused ribbon during non-print areas.
• TAG Enabled (When the head lever is set to TAG
position.)
• LABEL Enabled (When the head lever is set to Label
position)
• OFF Disabled.
(7) PRE PEEL OFF
This parameter is to choose whether to activate the pre-strip function.
When this parameter is set to ON, the top edge of a label is separated
(pre-stripped) from the backing paper before the label is printed. This
function is intended to make the strip issue easier in the case the labels
are hard to strip due to the label intensity, adhesive power, or the
printing speed.
• OFF Disables pre peel off
• ON Enables pre peel off
(8) BACK SPEED
This parameter is to choose a back feed speed.
In the strip issue, the back feed sped of 3 ips may cause a shortage of
feed amount due to a lack of torque, slippery media surface, etc. In
such case, reduce the back feed speed to 2 ips to secure the feed
amount.
• STD 3ips
• LOW 2ips
NOTE:
The print head may not be raised
depending on the rise of the
solenoid’s temperature.
NOTE:
1. Do not enable the ribbon saving
function when the ribbon saving
module is not installed. Doing so
causes ribbon slack and print
failure.
2. The ribbon saving option must be
selected according to the head
lever position. Incorrect setting
may disable the proper ribbon
saving function.
NOTE:
P
re-strip function is automatically
enabled when the print speed is set to
10 ips.