Filter
Top Products
2. PRINTER SETUP ENGLISH VERSION EO1-33089
2.6 Printer Setting
E2-15
2.6 Printer Setting
(Cont.)
2.6.1 User System Mode
Key functions in the system mode
Key Function
[MODE] Returns to the mode menu screen.
[CANCEL] or
[FEED]+[RESTAR]
Returns to the upper hierarchy.
Displays a next screen. [ENTER] or [PAUSE]
Saves the setting and returns to the upper
hierarchy.
Moves the cursor upward.
(Note 1)
[UP] or [RESTART]
Increases a value.
(Note 2)
Moves the cursor downward.
(Note 1)
[DOWN] or [FEED]
Decreases a value.
(Note 3)
[LEFT] Moves the cursor to the left.
(Note 3)
[RIGHT] Moves the cursor to the right.
(Note 3)
How to enter the User System Mode
The User System Mode consists of the following menus.
<1>RESET
Used to reset the printer.
<2>PARAMETER SET (⇒ Section 2.6.2)
Used to set the printer parameters.
<3>ADJUST SET (⇒ Section 2.9)
Used to fine adjust the print start position, cut position, etc.
<4>LAN/WLAN (⇒ Section 2.6.3)
Used to enable or disable the LAN communication and SNMP.
<5>BASIC (⇒ Section 2.6.4)
Used to set the function of basic program when it is loaded to the
printer.
<6>Z-MODE (⇒ Section 2.6.5)
Same as BASIC
<7>AUTO CALIB (⇒ Section 2.6.6)
Used to enable or disable the automatic calibration function.
<8>DUMP MODE (⇒ Section 2.6.6)
Used to print the data in the receive buffer for debug.
<9>LOG (⇒ Section 2.6.7)
Used to save print logs in a USB memory.
NOTES:
1. The cursor does not move any further when the selected option is listed
at the top or bottom.
2. The value does not increase or decrease any further when the selected
value is the upper or lower limit.
3. The cursor does not move any further when it is at the left-most or
right-most position.
4. Be careful the selected value does not become effective if the printer is
turned off without pressing the [ENTER] key.
PAUSE
RESTART
UP
RIGHT
ENTER
DOWN
CANCEL
MODE
LEFT
FEED
ONLINE
User System Mode
[PAUSE] Hold down [RESTART]
Hold down [MODE]