Filter
Top Products
2. PRINTER SETUP ENGLISH VERSION EO1-33089
2.9 Position and Print Tone Fine Adjustment
E2-66
2.9.1 Fine Adjustment (Cont.)
(8) RBN ADJ.<BK>
When the ribbon is slack or wrinkled and printing is affected, fine
adjust the ribbon motor torque.
(9) THRESHOLD <REFL.>
When you perform a threshold setting for the reflective sensor and found
the threshold needs to be adjusted, set a fine adjustment value.
This menu is accessible directly from the Threshold Setting Mode so that
the threshold can be manually set right away.
Manually set threshold = Peak voltage – The value set here
For details, refer to Section 2.10.
(10) THRESHOLD <TRANS.>
When you perform a threshold setting for the Transmissive sensor and
found the threshold needs to be adjusted, set a fine adjustment value.
This menu is accessible directly from the Threshold Setting Mode so that
the threshold can be manually set right away. .
Manually set threshold = Peak voltage – The value set here
For details, refer to Section 2.10.
+10
-15
+9
-14
High
Low
Motor torque
NOTE:
When “0.0 V” is se for this
p
aramete
r
, it is automatically
corrected to 1.4V (default)
after the power is turned OFF
then ON.
NOTE:
When “0.0 V” is se for this
p
aramete
r
, it is automatically
corrected to 1.0V (default)
after the power is turned OFF
then ON.
4.0V
0.0V
3.9V
0.1V
4.0V
0.0V
3.9V
0.1V