Filter
Top Products
2. PRINTER SETUP ENGLISH VERSION EO1-33089
2.6 Printer Setting
E2-14
2.6 Printer Setting
Depending on the settings of your host computer or an interface to be
used, it may be necessary to change the printer parameter settings.
Follow the procedures described below to change the printer parameter
settings to correspond to your environment.
NOTE:
I
ncorrect settings can cause the printer to function erroneously. If you have
any problems with the parameter settings, please contact your nearest
TOSHIBA TEC service representative.
F
or the settings this manual does not cover, please contact your nearest
TOSHIBA TEC service representative, or refer to the B-EX4T Series Key
Operation Specification.
ONLINE Mode
User System Mode
Power ON
[PAUSE]
PAUSE state
Hold down [RESTART]
Power OFF
Hold down [MODE]
• Reset
• Parameter setting (⇒Section 2.6.2)
• Fine adjustment (⇒Section 2.9)
• LAN/WLAN (⇒Section 2.6.3)
• BASIC (⇒Section 2.6.4)
• Z-MODE (⇒Section 2.6.5)
• Auto calibration (⇒Section 2.6.6)
• Dump mode (⇒Section 2.6.7)
• Log (⇒Section 2.6.8)
System Mode
Turn on the power while holding
down [FEED] & [PAUSE] or
[MODE].
• Self diagnosis
• Parameter setting
• Fine adjustment
• Test print (⇒Section 2.8)
• Sensor adjustment
• RAM clear
• Interface setting (⇒Section 2.6.10)
• BASIC mode
• RFID setting
• Real Time Clock (⇒Section 2.6.11)
• Z-MODE
• USB memory
• Reset