Filter
Top Products
222
Open the Paper Exit Guide and
remove the jammed paper.
Install the Drum Unit into the
machine, aligning the guides of
the Unit with the grooves inside
the machine.
Color coordinated “1” labels
have been affixed to the Drum
Unit and to the inside of the ma-
chine. Install the Drum Unit by
aligning these labels.
Make sure the Drum Unit is in-
serted inside the machine as far
as it will go.
IMPORTANT:
• Never touch the photocon-
ductive drum (the green sur-
face) of the Drum Unit. If the
surface is scarred or
scratched, it will cause print
quality problems.
• Do not expose the photocon-
ductive drum of the Drum
Unit to light for more than 3
minutes. If the Drum Unit is
to be left anywhere outside
the facsimile, be certain to
cover it with cloth, paper,
etc.
Clearing a Recording Paper Jam - continued
60
45
Install the Drum Unit
15
61
Remove the Jammed
Paper
(Paper Exit Area)
14
Holding onto the Toner
Cartridge’s handle, lower it into
the machine. Make sure that the
four pins (two on each side) fit
into the grooves inside the ma-
chine.
Color coordinated “2” labels
have been affixed to the Toner
Cartridge and to the inside of
the machine. Install the Toner
Cartridge by aligning these la-
bels.
As the Toner Cartridge is low-
ered into the machine, its
handle will rotate first to the rear
of the machine and then to the
front.
The cartridge will click into place
when it is completely installed.
40
2
2
2
2
41
42
Install the Toner Cartridge
16
NOTE:
Insure both sides of Paper
Exit Guide are properly latch
upon completion of jam re-
moval.
Close the Top Cover
17
Press down on the Top Cover
until a “Click” is heard to ensure
the latches engage.
Verify the display has returned
to the Standby Mode.
43