Filter
Top Products
95
This procedure will discuss Di-
rect Transmission when se-
lected as the default setting or
when Residual Memory has
been depleted.
Load the document face down
in the Document Support (see
page 82).
Adjust the resolution and con-
trast if desired (see pages 83
and 84).
Dial the facsimile number of the
remote party using any of the
four dialing methods.
• One Touch Key Dialing
... See page 89
• Abbreviated Dialing
... See page 90
• Alphabet Dialing
... See page 91
• Keypad Dialing
... See page 92
• Press
if a dialing er-
ror occurs.
Example of screen displayed
while a number is entered using
Keypad Dialing:
Once the facsimile number is
entered, the dialing starts.
Direct Transmission is used if
there is not enough residual
memory or when a large num-
ber of document pages are to
be sent, etc.
This mode is also useful if the
operator wishes to visually con-
firm the actual transmission of
the document to the remote par-
ty.
The documents will remain in
the ADF and be transmitted one
by one.
Direct Transmission
Load the Document
1
Dial the Facsimile
Number
2
Start Dialing
3
Direct Transmission as Default Setting
Line Connection to
the Remote Party
4
Once connected to the destina-
tion facsimile, the screen below
is displayed.
MAY-17 09:43 AM 100%
AUTO RECEIVE
Example of screen displayed
when Residual Memory has
been depleted:
MAY-17 09:43 AM 0%
AUTO RECEIVE
TEL NUMBER =(MAX128)
0559761234
DIALING
0559761234
If the destination facsimile is
busy, the screen below is dis-
played.
WAITING TO REDIAL
AUTO RECEIVE
If the redial procedure is com-
pleted without a success, the
screen below is displayed and
printed the Transmission Re-
port.
MAY-17 09:43 AM 100%
PRINTING LIST
After printing
MAY-17 09:43 AM 100%
LINE BUSY
COMMUNICATING
+81 559 761234