Filter
Top Products
227
Recording Unit Cleaning Procedure - continued
When the Recorded Image is not Clear... - continued
68
Wipe the Bottom
Side of Paper Guide
5
Install the Drum Unit
6
Press down on the Top Cover
until a “Click” is heard to ensure
the latches engage.
Verify the display has returned
to the Standby Mode.
43
Close the Top Cover
8
Wipe the bottom side of Paper
Guide with a dry cloth.
If the surfaces require moisture
to remove the dirt, use a cloth
slightly dampened with water to
remove the dirt, followed by a
dry cloth.
Install the Drum Unit into the ma-
chine, aligning the guides of the
Unit with the grooves inside the
machine.
Color coordinated “1” labels have
been affixed to the Drum Unit
and to the inside of the machine.
Install the Drum Unit by aligning
these labels.
Make sure the Drum Unit is in-
serted inside the machine as far
as it will go.
IMPORTANT:
• Never touch the photocon-
ductive drum (the green sur-
face) of the Drum Unit. If the
surface is scarred or
scratched, it will cause print
quality problems.
• Do not expose the photocon-
ductive drum of the Drum Unit
to light for more than 3 min-
utes. If the Drum Unit is to be
left anywhere outside the fac-
simile, be certain to cover it
with cloth, paper, etc.
45
Holding onto the Toner Car-
tridge’s handle, lower it into the
machine. Make sure that the
four pins (two on each side) fit
into the grooves inside the ma-
chine.
Color coordinated “2” labels
have been affixed to the Toner
Cartridge and to the inside of
the machine. Install the Toner
Cartridge by aligning these la-
bels.
As the Toner Cartridge is low-
ered into the machine its handle
will rotate first to the rear of the
machine and then to the front.
The cartridge will click into place
when it is completely installed.
40
2
2
2
2
41
42
Install the Toner Cartridge
7