Filter
Top Products
231
Using the TOSHIBA RAID Utility
Using RAID
5.375 x 8.375 ver 2.3
hard disk capacity will appear to the operating system as only
40 GB.
When you first start your computer
Each time you start your computer you will be prompted to
configure your computer for RAID-1 until one of the
following occurs:
❖ The computer is ready to enable for RAID-1. See the
steps on the following page.
❖ The computer is configured for RAID-0. See “Creating a
new RAID-0 array” on page 233 for more information.
❖ The computer’s secondary hard disk is partitioned and
formatted using the Disk Management utility. See your
Windows online help for more information.
When configuring the secondary hard disk for RAID-1 support,
all existing data on the secondary hard disk will be
permanently erased and will not be recoverable. Toshiba is not
responsible for any loss of data on the hard disk.
Your computer can only be configured for one type of RAID at
a time. It cannot be configured to use both RAID-0 and RAID-1
simultaneously.
1 Plug in the AC adaptor and power on the computer. (The
computer must be running from power provided by the
AC adaptor to perform these steps.)
2 After you have completed Windows setup and started
using you computer, the following screen appears.
NOTE