Filter
Top Products
MS860 WiFi Manual
NETWORK SETTINGS
Scan the Enter Group 10 bar code
Then scan: DHCP Space 1 CR
Lastly, scan: SE CR EE
Other than that last line, it’s pretty self-explanatory. Several parameters
can be modified together in one session, as above. Or, only one
parameter can be modified per session, as below. The last commands
- SE, CR, EE - are simply a sequence to end the programming mode,
and along with Enter Group 10 must be included whenever program-
ming network settings via bar code.
USING BAR CODES TO SET SCANNER NETWORK:
The WLAN default settings are shown below.
Item
IP Address
IP Subnet Mask
Gateway IP Address
SSID
RF Channel
WEP
Authentication Type
Default Setting
192.168.1.250
255.255.255.0
192.168.1.254
Wlandemo
6
Disabled
Auto
WLAN Default Settings:
Use the TCP/IP barcode chart on page 81 and the ASCII Chart on pages
83 to 86 to configure your scanner to your own network settings, as the
example below:
To turn DHCP on, scan the following sequence:
Please follow the steps below:
SSID: MySSID
IP: 192.168.1.100
Mask: 255.255.255.0
Scan the Enter Group 10 bar code
Then scan: SSID Space M y S S I D CR
Then scan: IP Space 1 9 2 . 1 6 8 . 1 . 1 0 0 CR
Then scan: MASK Space 2 5 5 . 2 5 5 . 2 5 5 . 0 CR
Lastly, scan: SE CR EE
17